arborwoodwork

Call Directions Website Contact the school

We specialize in custom furniture, design and build. Located in Georgetown, MD.

10/01/2026

My son Joe and I built a pamphlet rack for our church, St. Dennis. And my friend Mike helped me install it this week in the narthex (I had to look that word up, but church architecture fans will know it).

07/31/2026

My son Joe made a frame for the inside of my dust collector barrel. I wanted to fit a large trash bag inside the barrel to make disposal easier, but since there's vacuum inside the barrel, I needed a frame to hold the bag open. He cut and welded the frame from 1/4" steel. Works well!

07/09/2026

Recently wrapped up this kitchen for a repeat customer in Galena, MD. Cabinets constructed of white oak.

06/04/2026

Here's a vented toe kick panel for under a cabinet. I'm using a dado blade at 5/16" wide. I start the saw and slowly raise the blade into the work until it breaks through, and reaches my forward cut line. Then, the workpiece is fed through to the back cut line. The finished side is up, and covered with tape to get a clean cut.
Note that there's a risk when raising a dado blade into a workpiece, of the blade catching the piece and launching it backwards off the saw. Standing to the side, out of the potential pathway, is a good idea.

05/28/2026

When making doors, I select for grain and color of the wood (in this case, rift-sawn white oak) before milling into rails and stiles. After assembly, because of the natural variation of the wood, I spend some time arranging the doors for a harmonious transition of color and grain pattern between adjacent doors before installing. This results in a more cohesive visual presentation.

05/15/2026

Making doors with veneered plywood panels surrounded by solid oak trim. I'm attaching the trim to the panel using the Festool Domino system. This makes for a strong joint that looks neat on both sides of the door. For this application, I mounted the Domino machine flat to the bench and am referencing all my machining operations off the back of the door, which keeps all the parts aligned and reduces error. Batching operations also helps reduce mistakes, and speeds things up.

05/08/2026

Thank you for your support Cecil County Office of Economic Development - OED

05/04/2026

Doors and drawers going in, and getting close to completing this custom kitchen. I really enjoy this stage in a project, where a lot of work in the shop translates into visible progress on the site.

04/28/2026

Very happy with the new lettering on my work van, done by Graphics, Signs and Wraps in Galena, MD. Rose and Al were great to work with. Highly recommend!

04/22/2026

Tried out a new method for scribing trim that I learned from Cabinet Mastery - a group for cabinet makers to improve their craft and business skills.
Make a row of biscuits or dominoes on your trim piece and cabinet where it should be in its final position. Then make a second row on your trim piece with a fixed offset (e.g 3/4"). Place the trim piece on your cabinet in the offset position and use a thickness block of the offset (3/4" in this case) to scribe the wall or ceiling. Using blue tape and a scribing knife is the most accurate. Take the piece down, cut to the scribed line, ideally back beveling the cut 15 degrees or so, and then reinstall the trim piece using the original row of biscuits or dominoes. It should fit perfectly.

Address

Georgetown, MD
21930

Telephone

+14432860742

Website

http://www.arborgeorgetown.com/

Alerts

Be the first to know and let us send you an email when arborwoodwork posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The School

Send a message to arborwoodwork:

Want your school to be the top-listed school/college in Georgetown?