NStar Robotics and Electronics

I'm feeling nostalgic😅The project below was done some 16 years ago.
I built the unit using Basic Stamp II MCU, while DC motor driver n IR sensors was from my own as driver IC weren't not available then.

Object Avoiding Rover Robot with DC Motor &Basic Stamp This Object Avoiding Rover Robot sizes like a shoe box and requires a room area of 50 sq ft to operate. It uses 1X Basic Stamp 2, 3X PNP Opto Sensors, 2X 12V...

Much like electricity, pressure differential is there and could be dramatic, so do be careful. 🤔

Gear box assembly requires precision and patience.

ME students gain experience on 3D CAD drawings, part assembly drawings, and building up working samples.

All common tasks of a mechanical engineer.

We wish You Happiness, Health and Holy Molly Goodtime. . 🎉🎉🎉🎉🎉NS Monsters