Sohail Safety Study

You and only you are responsible for your life choices and decisions.

Golden Rules of safety.

Calculating Fall Clearance Distance:
°Using a Retractable Lifeline

• First, add the maximum free fall distance (2 ft.) with a retractable lifeline to the maximum deceleration distance (3-1/2 ft.) to the average height of a worker (6 ft.).

• Then, add a safety factor of 3 ft. to allow for the possibility of an improperly fit harness, a taller than average worker and/or a miscalculation of distance.

• The total, 14-1/2 ft. is the suggested safe fall clearance distance for this example.

† NOTE: When using a retractable lifeline, the distance is calculated from the point where the retractable attaches to the back D-ring of the worker’s harness.

((SAFETY ACRONYMS))

1 - HSE - Health Safety Environment
2 - PPE - Personal Protective Equipment
3 - ANST - American National Standard Institute
4 - NFPA - National Fire Protection Association
5 - OSHA - Occupational Safety and Health Administration
6 - IOSH - International Occupational Safety and Health
7 - NEBOSH - National Examination Board in Occupational Safety and Health
8 - ISO - International Standard Organization
9 - PM - Particulate Matter
10 - AIES - All Institute of Engineering and Safety
11 - AISE - Advance Institute of Safety Engineering
12 - OSHAS - Occupational Safety and Health Assessment Series
13 - OH & SMS - Occupational Health and Safety Management System
14 - CFR - Code of Federal Regulation
15 - APR - Air Purifying Respirator
16 - ASR - Air Supplying Respirator
17 - SCBA - Self Contained Breathing Apparatus
18 - SCUBA - Self Contained Under Water Breathing the Apparatus
19 - PFAS - Personal Fall Arrest System

20 - P - Pull the Pin
A - Aim Base of the Fire
S - Squeeze the Trigger
S - Swipe Side by Side

21 - R - Rescue
A - Alarm
C - Confined
E - Extinguished

22 - DCP - Dry Chemical Powder
23 - CO2 - Carbon Dioxide
24 - LPG - Liquid Petroleum Gas
25 - LNG - Liquidfied Natural Gas
26 - FFE - Fire Fighting Equipment
27 - WSC - World Safety Council
28 - FEE - Fire Extinguisher Equipment
29 - CNG - Compressed Natural Gas
30 - AFFF - Aqueous Film Forming Foam
31 - GFCI - Ground Fault Circuit Interrupted
32 - CS - Confined Space
33 - ELCB - Earth Leakage Circuit Breaker
34 - MCB - Miniature Circuit Breaker
35 - NSC - National Safety Council
36 - NACO - National AIDS Control Organization
37 - SOP - Safe Operating Procedure
38 - HAZCOM - Hazardous Communication
39 - RPE - Respiratory Protective Equipment
40 - HAZOP - Hazardous Operability
41 - FSC - Fire Safety Co-ordination
42 - H2S - Hydrogen Sulphide
43 - SO2 - Sulphur Dioxide
44 - IDLH - Immediately Danger to Life and Health
45 - STEL - Short Term Exposure Limit
46 - LEL - Lower Explosive Limit
47 - PEL - Permissible Explosive Limit
48 - UEL - Upper Explosive Limit
49 - OEL - Occupational Explosive Limit
50 - HAZWOPER - Hazardous Waste Operability and Emergency Recovery
51 - CPR - Cardio Pulmonary Respiration
52 - PPM - Part Per Million
53 - TLV - Threshold Limit Value
54 - SWP - Safety Work Permit
55 - PTW - Permit to Work
56 - ECO - Echo Control Officer
57 - WDO - Waste Disposal Officer
58 - ALARP - As Low As Reasonably Practical
59 - HWP - Hard Work Permit
60 - CWP - Cold Work Permit
61 - VEWP - Vehicle Entry Work Permit
62 - EIWP - Electrical Isolation Work Permit
63 - BP - Blancket Permit
64 - EMS - Emergency Management System
65 - EP - Excavation Permit
66 - LWP - Lifting Work Permit
67 - SWP - Safety Working Process
68 - SWL - Safe Working Load
69 - EHO - Environment Health Officer
70 - FPS - Fall protection System
71 - FPR - Fall Protection Required
72 - WRS - Wire Rope Sling
73 - SWS - Synthetic Web Sling
74 - SLC - Sling Load Capacity
75 - SLI - Safe Load Indicator
76 - LOTO - Lock Out and Tag Out
77 - HIRA - Hazard Identification and Risk Assessment
78 - JSA - Job Safety Analysis
79 - JHA - Job Hazard Analysis
80 - JRA - Job Risk Analysis
81 - WPA - Work Permit Authorization
82 - WPC - Work Permit Control
83 - GK - Gas Kit
84 - GM - Gas Monitor
85 - PH - Potential Hazard
86 - TPI - Third Party Inspection
87 - ACB - Air Circuit Breaker
88 - ZAP - Zero Accident Performance
89 - WMITAB - Waste Management Industry Training Advisory Board
90 - MSDS - Material Safety Data Sheet
91 - AEP - Authorized Electrical Person
92 - STP - Sewage Treatment Plant
93 - WPA - Work Permit Application
94 - NBC - National Building Code
95 - PRC - Preparation Reinstatement Certificate
96 - BLEVE - Boiling Liquid Expending Vapour Explosion
97 - COSHH - Control of Substance Hazardous to Heat
98 - LTFR - Lost Time Frequency Rate
99 - LMRA - Last Minute Risk Assessment
100 - CAZ - Control Access Zone
101 - WPV - Work Permit Validity
102 - EWO - Engineering Work Order
103 - PPD - Partial Permanent De escalation

Creating a parthway to transformation a health and safety culture.

Grinding Safety

Safety Excavations & Underground Works...!!!!

’ Ignorance of rules, is the major root cause for a accidents’ one mistake can take your life ,,ensure and provide hard barricading at workplace .

Scaffold safety 🦺

Not all storms come to disrupt your life , some come to clear your path.

Lamination inspection
Laminations are unwanted discontinuities lying parallel to the pipe surface that are usually marked by a concentration of non-metallic material,
Surface-breaking laminations can be initiation points for fatigue cracks and hydrogen cracking in the pipe body. Lamination may cause detrimental planar features and cracking in welds when the two coincide, such as SAW weld hot tears due to laminations.

Problems are the doors to opportunities.