Sunrise Chemical Industrial Co.,Ltd

Pu foam,gap filler

Wood Flooring Glue Adhesive.

Product Description
Sunrise SMP-853, SMP (Silane-Modified Polymer) Nail-free Sealant is a one-component, toothpaste-like sealant with high initial grab and high bond strength, convenient to use. The product is made from the imported Silane-Modified Polymer material; It is eco-friendly, not containing formaldehyde, benzene, toluene, xyleneand or irritating smell. It shows excellent adhesion on hook, floor, tile, aluminum plastic shelf, goods rack, picture frame etc.. SMP-853 stands out for its initial adhesion, water resistance and long-lasting viscosity.

Application
Sunrise SMP-853 can adhere well on most house building and decorating materials: hardware of kitchen and toilet, wood, glass,cement wall, stone wall(marble), floor, tile,aluminum plastic shelf, goods rack, picture frame etc..

Sunrise SMP801M Long-Lasting Anti-Mildew Sealant
Product Description
SMP-801M，SMP(Silane-Modified Polymer)Long-Lasting Anti-Mildew Sealant is a one-component, moisture curing sealant. The product is antifouling and solvent-free with long-lasting water-proof and mildew-proof property and excellent adhesion to most building materials. It is widely used for the purpose of water- proof and mildew-proof in building.

Application instructions
Substrate surfaces must be clean and free of grease, dust etc. Use solvent to clean the surfaces when necessary.Surfaces must be dry before use.
Protective tape must be attached to both sides of the surface that is to be bonded.
Cut a nozzle to desired size.Apply sealant continuously and evenly with a gun.Make sure that the sealant contacts the substrate closely. Tear off the tape before sealant incrusts.

Sunrise SMP881 Sealant for Prefabricated Building External Walls
Introduction
SMP-881,SMP (Silane-Modified Polymer) Sealant for Precast Buildings is one-component, paintable, eco-friendly, solvent-free It cures at room temperature and has excellent adhesion to most substrates. It is widely used in the sealing of exterior wall in precast buildings and the bonding of building materials.

Application areas
Usually, SMP-881 bonds well to the following substrates without primer: aluminum, stainless steel, coated steel, zinc, copper, brass, powder coated metal, painted metal, glass, PVC, GRP, coated or painted wood, etc.



Application instructions
Substrate surfaces must be clean and free of grease, dust etc. Use solvent to clean the surfaces when necessary. Wait until the surface is dry before use.
Usually SMP-881 is applied without primer. For the substrates that primer is required by Adhesion Test, use a special brush to apply a thin layer of primer on the substrate surface. After it is cured, apply the sealant. Primer must be used again if sealant is not applied in 8 hours.
Painting on the sealant can be done only when the sealant surface has hardened (usually 48 hours after application)

Safety advice
Keep out of reach of children.
Do NOT contact uncured sealant with eyes. In case of contact with eyes, rinse immediately with plenty of water.
Do NOT contact uncured sealant with skin for long time.

Application limitation
Do NOT use in the unventilated place, for the sealant must react with the v***r in the air for curing.
Do NOT use on the surface which is constantly wet.
Do NOT use on the substrates which excrete grease, plasticizer or solvent.
Not suitable to untreated PE, PP and PTFE plastics.
Do NOT use when the surface temperature is lower than 4℃ or higher than 40℃.
Conduct Adhesion Test on your substrates before application.